How You Can Install a Car Antenna Cable Easily

The first thing many people do in their car is they installs a new car stereo if they needs, mainly to
increase enjoyment many people do it to get the best feelings of melodies. The most critical elements for the stereo is a fixed antenna, because without a fixed antenna, you can't listen to the radio. If your antenna is broken down or the cable is not properly connected. You should replace the entire antenna properly. This is not a difficult part to do. But it will take some time to fix it properly, and you must needs to use some special tools to fix. 

The things that will need to fix all those:

 

• Replacement Antenna
• Screwdriver
• Wire Cutters
• 1/4-inch Ratchet, Extension and Sockets
• Removal Antenna tool
• and much more

#1
1st of all remove the antenna from the wing using a removal tool antenna. The tool will loosen the nut of the antenna and will allow you to throw the antenna base from the bottom of the wing.

#2
Now, open the hood and locate the grommet in the firewall of the passenger side that the antenna cable goes fine. Push out the hole with the screwdriver to pop the rubber of the outer ring around the sides. Then cut the antenna lead using wire cutters and pull the rest of the antenna line outside the ring hole in the engine compartment using your hands.

#3

Bolt replacement antenna on the wing using the antenna tool, and then run the wire antenna inside the wing and inside the firewall, pressing the ring in place, and finishing the engine bay portion of the installation. good quality 4 Place your foot on the brake and shift the truck at a low speed. Then pull the bezel surrounding the radio and the meter panel with your hands. With slight pressure, the hoop dashboard will Release the backboard.

#5
Unbolt the stereo from the dashboard using the 1/4-inch ratchet, extension and sockets. Then pull out and disconnect the stereo wiring and antenna from the back of the board with your hands.

#6
Lean under the instrument panel and pull out the old antenna from the board with your hands. Then run the new antenna cable from the board with your hands to work the antenna leaves the board. This could mean opening the front passenger glove compartment and moving the cable through the dashboard.

#7

Connect the wiring for the stereo behind the back of the deck and connect the new antenna cable to the rear of the deck as well. Then screw the stereo behind the dashboard using the 1/4-inch ratchet, and clip the rear dashboard bezel into place in the reverse order of installation.