How to connect a Sub to a stereo factory on Your Car

Adding bass in a car factory audio system, there's no easier or more effective way than to add a sub-woofer. A sub-woofer is gonna provide the low-end punch that makes sound more clear and regardless of the type of music you listen to. It's the most working & effective way ever. If you like you can have a technician to do the installation, or you can connect your own and save the cost of labor(s).

Things you will need:

• Phillips-screwdriver
• Amplifier wiring kit
• Investing Tool
• Amplifier
• The Show More Instructions

 

How to wire a Sub to a stereo factory:

#1
Disconnect the negative battery cable from the vehicle battery. The negative cable is called a black cable. Connecting it (the negative cable) the car battery to the frame of the vehicle. Use a normal screwdriver to loose the pin and finally you will be able to remove the clamp from the negative(-) line.

#2
Now you should remove the stereo from the panel (dashboard). They should have the access to each connections on the back of each unit.Then it will be perfect enough for next step.

#3
At this step place the sub-woofer & amplifier in the trunk of the your car. The amplifier can be placed at other areas (such as under the seat). But the body should have an easier connection to the sub-woofers. Those things you have to focus to get the most amazing result that you are accepting.

#4
Connecting the ring terminal, it should give you the best positive result of the battery. And you must ensure that the security has been removed from the terminal. And that should be done before connecting the power cord into the terminal ring.

#5
Then route the power cord from the amplifier ring terminal. Now you have use a grooming tool to remove the coating that ensures the carpeting in the vehicle floor. The panels you can easily replace.

#6
And now route the signal cable and must enable to lead from the stereo of the trunk along the opposite side of the vehicle. The power cable will make problem if  the signal cables are in the same line.

#7
Now connect all those (power cable, signal cable) and now it's time to turn-on lead to the amplifier.

#8
Now, using speaker cable Connect the sub-woofer.

#9
Now you have to connect the negative (-) battery cable. Place the clamp around the negative (-) lead. Tight the bolt on the clamp until the clamp can not be moved to the lead by your hand.


That's all about How to connect a Sub to a stereo factory. Hope you got this article valuable & hope it gave you a bit knowledge about the issue you were getting.